Ultra-Cheap Deals RC Programming Card brushless Go ESC Electronic Ultra-Cheap Deals RC Programming Card brushless Go ESC Electronic $8,Programming,ESC,Card/Electronic,/curatage82503.html,Programming,Vehicles , Remote App Controlled Vehicles , Remote App Controlled Vehicle,sandramihanovich.com,Go,Card/brushless,RC $8 RC Programming Card/brushless ESC Programming Card/Electronic Go Vehicles Remote App Controlled Vehicles Remote App Controlled Vehicle $8 RC Programming Card/brushless ESC Programming Card/Electronic Go Vehicles Remote App Controlled Vehicles Remote App Controlled Vehicle $8,Programming,ESC,Card/Electronic,/curatage82503.html,Programming,Vehicles , Remote App Controlled Vehicles , Remote App Controlled Vehicle,sandramihanovich.com,Go,Card/brushless,RC

Ultra-Cheap Deals RC Programming Card Max 71% OFF brushless Go ESC Electronic

RC Programming Card/brushless ESC Programming Card/Electronic Go

$8

RC Programming Card/brushless ESC Programming Card/Electronic Go

|||

Product description

Compatible: suitable for 1/8, 1/10, 1/12, 1/14, 1/16, 1/18 remote control car

Low voltage detection: 3.1V, 2.9V, 2.7V, no detection

Startup mode: normal, soft, rape

Maximum braking force: (25A, 45A, 60A) 50%, 25%, 75%, 100% (default 50%).

                                        (80A, 120A) 25%, 50%, 75%, 100% (default 25%)

Maximum reverse force: 25%, 50%, 75%, 100%

Neutral range: 9% (narrow), 6% (normal), 12% (wide) (default is 9%)

Size: 60x46x6mm; cable length: 40mm

Weight: 50g

Instructions for use of programming card:

   1. Connect the BEC cable of the ESC to the programmer, and follow the color direction shown above (the black ground wire is next to the right frame)

   2. Connect the ESC and turn on the power switch (80A and 120A should be pressed and held down the ESC button)

   3. When the green LED on the programmer flashes twice and then stays on, it indicates that the ESC and the programmer are successfully connected

   4. Press the "↓" key of the programmer to select different programs

   5. Press the "↓" key of the programmer to select the content that needs to be set in the currently selected item, and the LED light on the selected content will light up

   6. Press the "Program" key of the programmer to set the successful programming content. The programming LED lights up when programming is started, and turns off after more than 5 seconds to indicate successful programming. Otherwise, programming fails (reprogram after turning off the power)

   7. Press the "Reset" button of the programmer to restore the factory default settings. The programming LED lights up when programming is started, and turns off after more than 5 seconds to indicate successful programming. Otherwis

RC Programming Card/brushless ESC Programming Card/Electronic Go